Yamato DX402 Betriebsanleitung PDF herunterladen (Seite 15)

4. Operating procedures

List of operation modes and functions

Functions of the unit are as shown below:

№ Name Description Page

Overheat prevention

function

Automatic overheat prevention function:

This function is linked to the unit set temperature and has

been set to so that it is automatically activated (returned

automatically) at a temperature 12℃ higher than the set

temperature in the bath.

Standalone overheat protection device (Thermostat)：

When the temperature in the bath reaches the set

temperature of the standalone overheat protection device

(Thermostat), its heater circuit trips to shut off controller

operation.

The temperature can be set with the manual dial on the

hydraulic overheat prevention device installed at the right

side of the unit.

P. 1 5

Calibration

Offset function

Calibration offset function compensates any differences

between the target temperature in the bath and the control

temperature of the controller (sensor temperature.)

The function can compensate to either plus or minus side

for the whole temperature band of the unit.

This compensation can be set with the SUB MENU keys.

P. 2 3

3 Setting lock function

This function locks the set operation status.

The lock can be set or released with the SUB MENU key.

P. 2 4

Power outage

compensation function

This function returns the main unit operation to the resume

status after recovery from power outage, or keeps the

current stop status.

This compensation can be set with the SUB MENU keys.

P. 2 5

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 39 40

Keine Kommentare

Yamato DX402 Betriebsanleitung Seite 15