Yamato DX402 Betriebsanleitung PDF herunterladen (Seite 20)

4. Operating procedures

Operating procedures (quick auto stop operation)

When you want to correct set

temperature or set time, or

change settings

When you want to change settings, press the ▼▲ keys on

the current screen to enter the setting mode where you can

change settings. Blinking stops three seconds after three

seconds after change and setting is completed. Note,

however, that temperature changes after timer activation are

counted also while temperature is changing.

When you want to change settings before timer activation,

press the TIMER key on the current screen to enter the

setting mode where you can change settings. Enter a time

duration from when the set temperature is reached to the

time the device shall be stopped.

When you want to change settings after timer activation,

press the TIMER key on the current screen to enter the

setting mode where you can change settings. Note, however,

you need to set a time calculated by adding the time already

passed to the time to be added.

After change has been made, press the RUN/STOP key to

complete the process.

When you want to stop quick auto stop operation in the

middle of it, press the RUN/STOP key long once to stop

device control once, then make settings again in the

appropriate mode.

In terms of the remaining time display a blinking

dot indicates count down and an illuminating dot indicates a

wait status (while temperature is increasing or decreasing to

the set temperature) during which the timer has stopped

counting.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 39 40

Keine Kommentare

Yamato DX402 Betriebsanleitung Seite 20